Yeti engraving settings for 10W Diode or 2W IR

Snapmaker 2.0
1

Greetings:

I want to engrave a yeti tumbler for my son and am looking for a good target set of settings so that I don’t ruin an (expensive) Yeti tumbler.

I have both the 10W diode laser and 2W IR laser for my A350. I have been using the 2W with the rotary attachment on other cups, but can switch to the diode if that is preferable.

I have searched on the forums, but just can’t seem to find any answers, just other people asking similar questions.

Thank you in advance for sharing the results of your own projects!
-Terence

2

I did a few Yeti Jrs with the A350 + Rotary. I used a workspeed of 2000mm/min, 45% power, and 0.08 interval with the 10W blue diode. Afterwards, scrub with a melamine sponge (brand name magic eraser).

1 Like