The ABL on my A350 is eithe rnot working at all, or just doesn’t take enough measurements to be effective. What’s going on here? This is basically Marlin firmware right? ABL has been around and working properly forever. Why can’t Snapmaker get it right?
Also, when you you get it to work period, it would be nice to be able to select the number of grid points for more accurate ABL.
If you are on the latest firmware you can set the number of points up to a 5x5 grid
I think I am on the latest…where is that setting? I couldn’t locate it.
Thanks in advance!
Unfortunately I cant tell for sure, I’m mid print
I think you have to have the 3D print head attached, then I think settings, then calibration, then you can pick the grid size
Edit: it’s settings > 3D printing > grid size
I will check it out as soon as I am not also midprint 
Thanks!