What you think about the new products / upgrades today?

I am a bit lost. Looking at the code here and here I would assume the following:

  • new X/Y: 20mm pitch, 160 steps / mm, 3200 steps / turn, 0.00625mm resolution
  • new Z, old X/Y/Z: 8mm pitch, 400 steps / mm, 3200 steps / turn, 0.0025mm resolution

Can anyone confirm this or provide correct values?
Looking at the torque values here I would highly doubt that any finer micro stepping is done as acceleration forces already put the machine at its limit. So am I right to assume that I get quiet movement at the cost of a lower X/Y resolution? The higher speed is not relevant to me.

I have waited patiently and eager for the new modules to come out, but this makes me really reconsider whether to order them or not… or has this no visual/measurable impact?