Maybe you folks could help. I printed a gear and spring in place to check if it would work. The teeth got connected to spring , so my wall tolerance was off? Where do I adjusted in Cura? It is the test print from the link below. [image] PRINT-IN-PLACE SPRING LOADED BOX by Turbo_SunShine T…

I have printed this on A350 works great. very clever design As @clewis says check E steps you are over extruding if the teeth get connected to the spring. There’s also some large bridges on the top layer that becomes the side that are a bit tricky, I have added an additional fan and had to turn i…

Esteps yeah but also try slicer flow calibration after that I always have a tough time with that print, the box always works but the latch is junk lol Teaching Tech 3D Printer Calibration (teachingtechyt.github.io)

Wall Tolerances

Snapmaker 2.0 (3-in-1)

clewis February 26, 2021, 2:01am 2

Have you adjusted your E steps and tested your bed clearance calibration? If not, check out the getting started guide. If so, can you upload a photo of your print?

Topic		Replies	Views
3D printed walls are too thick Snapmaker 2.0 (3-in-1)	2	489	November 10, 2021
PLA parts looks nice but don’t fit Snapmaker 2.0 (3-in-1)	8	709	June 13, 2022
Gaps in wall lines Snapmaker 2.0 (3-in-1)	8	1427	June 22, 2021
Print accuracy and margin Snapmaker 2.0 (3-in-1)	14	1540	November 7, 2020
Diamater failure Snapmaker 2.0 (3-in-1)	1	302	November 18, 2021

Wall Tolerances

Related topics