I am trying to print this part for a Halo ODST cosplay, but the layer lines are really inconsistent and there are even some weird vertical artifacts. I’ve attached a photo near the end of the print that shows the poor quality. Prior to the print I ran through all of the Orcaslicer calibration tests …

Troubleshooting 3DPrint Quality

xchrisd March 25, 2025, 6:12pm 2

May share any of your settings?
Did you calibrate your e-steps? - >Extruder calibration is a must

Topic		Replies	Views
Printing quality - lines printed Snapmaker 2.0 (3-in-1)	49	2834	June 4, 2021
Help Needed, can’t get a good print Snapmaker 2.0 (3-in-1)	32	1053	August 6, 2021
3d printing problems I have Snapmaker 2.0 (3-in-1)	88	2117	August 31, 2023
Snapmaker Orca Calibration Steps Are Worth It Snapmaker 2.0 (3-in-1)	3	423	September 9, 2025
Can't get decent prints Snapmaker 2.0 (3-in-1)	17	1268	February 2, 2021