U1 Video Guide: Toolhead Connection Failure Troubleshooting
Hi U1 community,
If you encounter a toolhead connection issue on your Snapmaker U1, this video walks through the issue description, possible causes, and troubleshooting steps.
The video is organized into four parts:
0:06 Part 1 – Issue Description
0:21 Part 2 – Possible Causes
0:45 Part 3 – Troubleshooting: Connection Failure on a Single Toolhead
4:03 Part 4 – Troubleshooting: Connection Failure on All Toolheads
Helpful Resources
If the issue persists after troubleshooting, please contact our technical support team.
U1 Video Guide: Hotend Replacement & Setup
Hi everyone,
In this video, we’ll show you how to replace and set up hotends with different nozzle sizes on the Snapmaker U1.
00:06 Part 1: Hotend Selection
00:33 Part 2: Hotend Replacement
00:49 Part 3: Firmware Setup
01:46 Part 4: Software Setup
If you’re planning to switch nozzle sizes, this video walks through the full process step by step.
Watch the full tutorial here:
If you have any product usage questions or need further assistance, please contact our technical support team.
2 Likes
U1 Guides: Auto Loading Failure Troubleshooting
Hi everyone,
This video walks through troubleshooting auto loading failure on the Snapmaker U1, including two common cases: feeder LED off and feeder LED red.
In this video:
00:11 Part 1: Issue Description
01:34 Part 2: Troubleshooting (Feeder LED Off)
05:52 Part 3: Troubleshooting (Feeder LED Red)
Watch the full tutorial here:
Helpful resources:
- U1 Side Panels Removal Guide:
- U1 Abnormal Extrusion / Air Printing Troubleshooting:
If you have any product usage questions or need further assistance, please contact our technical support team.
1 Like
