Snapmaker Artisan Quick Swap Toolhead Plate (Adjustable Version) Released

Artisan Quick Swap Toolhead Plate (Adjustable Version) is specially designed for Artisan users who have purchased 20W/40W Laser Module and need an additional Quick Swap Toolhead Plate.

Orders placed before December 25th at 6:00 p.m. CST for the 20W/40W Laser Module will receive a unique coupon code via email to claim a free Toolhead Plate. (Please note: To ensure the discount code is effective, please use the same email address when placing an order for the 20W/40W laser module for Artisan.)

Orders placed after December 25th at 6:00 p.m. CST for the 20W/40W Laser Module will automatically include the Quick Swap Toolhead Plate—no separate purchase necessary.

Please review our FAQ and specific details for any questions you may have:



Installation guide:…/install_the_quick_swap…

For any additional inquiries or feedback, feel free to contact us at or leave a comment below.

1 Like

Hi Zoe

It’s great that the quick swap toolhead plate is available!

Unfortunately I’m not able to order, when pressing the buy button, an error message appears:

Did someone else experience that?

Hi @tux19

We have received a response from our IT department regarding the page crashes you have been experiencing. The issue is likely related to a network problem. To troubleshoot this issue, we recommend that you try the following steps:

  1. Change your web browser and try accessing the page again.

  2. Open the browser in incognito or private browsing mode and attempt to access the page once more.

If the issue persists after following these steps, please do not hesitate to contact for further assistance.

Hey guys. This may be an odd request. But while those of us (myself included) who have the 40w module and also have ordered the new adjustable quick swap tool head setup wait for them to arrive, can you provide a file for us to at least 3d print a usable tool head plate to use in our existing quick swap setup so we can at least use the laser?

I know we will have to provide longer screws still as the ones from the 10w module are too short for the 40w (I found out the hard way). But this could at least allow us to have plates on all 4 modules to quick swap, without needing to remove a plate from one module.

I looked in all the usual spots online but didn’t find a file that was fully compatible with the artisan. Grabcad did have the new adjustable setup itself actually, but the plate was not included.


Hi @Zoe

Indeed it seemed to be a DNS issue on my side.
I could order the plate now.


1 Like

I just found someone made an STL for the toolhead plate for anyone who hasn’t gotten one yet. Linky here: Toolhead Plate Snapmaker Artisan by Rainerox - Thingiverse