Snapmaker 2.0 FAQ Page

Hi folks, this is Edwin from Snapmaker. We will continue writing and publishing FAQs on this page regularly.

Please read through them and try to find your issues. If you have any questions about any articles in this section, please feel free to contact us and leave a comment here.



3 Likes

For those who have issue with Snapmaker 2.0, you can find the fault code of the issue via Snapmaker Luban.
Please connect the machine with your PC via the provided USB cable.

  • Launch Snapmaker Luban
  • Select the correct serial port
  • Input the command in the console

In Luban console, input M2000 S0 .
image

HEX Binary Shifting digits Error message
0x00000001 1 1 LOST EXECUTOR
0x00000002 10 1<<1 NO ANY LINEAR MODULE DETECTED
0x00000004 100 1<<2 NMOS FOR CONTROLLING BED IS BREAKDOWN
0x00000008 1000 1<<3 FLAG_FILAMENT
0x00000010 10000 1<<4 LOST SETTINGS
0x00000020 100000 1<<5 LOST EXECUTOR
0x00000040 1000000 1<<6 POWER LOSS
0x00000080 10000000 1<<7 HOTEND HEATFAIL
0x000000100 100000000 1<<8 HEATED BED HEATFAIL
0x000000200 1000000000 1<<9 HOTEND RUNAWAY
0x000000400 10000000000 1<<10 BED RUNAWAY
0x000000800 100000000000 1<<11 HOT END SENSOR BAD
0x000001000 1000000000000 1<<12 BED SENSOR BAD
0x000002000 10000000000000 1<<13 LOST LINEAR
0x000004000 100000000000000 1<<14 HOT END MAXTEMP
0x000008000 1000000000000000 1<<15 BED MAXTEMP
0x000010000 10000000000000000 1<<16 BED SHORT CIRCUIT
0x000020000 100000000000000000 1<<17 HOT END SHORT CIRCUIT
0x000040000 1000000000000000000 1<<18 HOT END SENSOR COMEOFF
0x000080000 10000000000000000000 1<<19 BED SENSOR COMEOFF
0x0000100000 100000000000000000000 1<<20 UNKNOWN MODEL
0x0000200000 1000000000000000000000 1<<21 DOOR OPENED
0x0000400000 10000000000000000000000 1<<22 POWER DETECT ERR
0x000080000000 10000000000000000000000000000000 1<<31 UNKNOWN ERR
2 Likes