Simplify3D 5.1 Machine Control

[MooseJuice]

I am not sure why I can’t seem to connect to my printer from Simplify3d. I used to be able to do it with Cura.

Does anyone know what the “port” needs to be? I have the IP address just fine.

[xchrisd]

It seems to be 8080, i havent tested yet but this thread has all information needed, i guess:

Guide: Automatic Start via Drag/Drop

This is the “wireless” portion to round out my full Lightburn control guide, found here: Since my main snapmaker (pretty much stays setup with the 10W + Enclosure) is far away from my PC, using a cable + Lightburn isn’t an option. I usually just used Luban to start files. However, as many of you know, their software is slow and iffy, so why not bypass it? Note: Be sure to read all the edits at the end of the post for more info. There’s a few pre-requisites and I’m setting this up on a windo…