Hello, Everyone since I got the snapmaker I saw this issue with the return position to the work in progresses been pause and then resumed during the 3D printing.
Please , help and advice.
Oscar,
I am sorry, but you’ll have to explain more clearly what you’re talking about. I doubt if anyone understands what you are trying to say.
1 Like
Pause is known to break any gcode that uses G91 relative movements, does that apply here?
1 Like
Hello everyone,
my apologies for the confusion with the description of the issue .
simple.
If you resume( stop the process when is printing). to check my work 3d printing process.
the printer once it is resume it moves to a location and waits until is been resume again.
Well.
my problem was that it did not retuned where the 3d printing previously stop.
I did started and a Different location and my work was scrap.
and the problem or issue was that the printer need it to be rigid table.
Sorry and thank you for the feedback.