Print does not stick

[CthulhuLabs]

Check out my post here:

Recommendations For Successful Prints

Hi all, I was in the process of writing this up as a reply to another thread when I realized that this would be better as its own here. I have been using 3d printers for a few years now and wanted to share some not so obvious things that definitely help get great prints out of SnapMaker and other printers. Many of these things are stuff I wished someone else had told me about when I got my first printer. Use a different slicer. Do not get me wrong, SnapMaker3D is pretty good when you are just…

I just spent over an hour writing down the things that I found help with printing on my SnapMaker.