[Official] Ready to Try for CNC

[macklebee]

Far from a complete or even a partial tutorial, but ESTLCAM allowed me to get decent initial results.

Estlcam settings for CNC carving

I have been meaning to learn the cnc side of snapmaker a handful of times, and decided to finally to figure out how to properly use it. First thing I learned was that there was not much information out there on how to set it up. The inherent snapmaker instructions lean towards the 2d stuff and point towards using fusion360. Fusion360 was a no-go with me, so fortunately I found others have posted information about other cnc carving software like Estlcam. I followed their simple video showing ho…