I’m never able to get my print of the print-bed without damaging the bed and the print. I auto-calibrate the printer a lot and often use a Z-offset when the print is already going on. My questions are, how do I make it non-sticky when the print is done and how do I get the leftover plastic of the be…

My print always sticks on the bed

Atom October 29, 2020, 11:33am 3

Your z offset is too low, for more info check out this thread: 3D prints stick WAY too well!

Edit: and check out this post for how to clean the bed
Cleaning bed tricks

Topic		Replies	Views
3d print sticks to the bed Snapmaker 2.0	4	2220	August 11, 2020
3D prints stick WAY too well! Snapmaker 2.0	51	5841	March 15, 2021
My print bed is all over the shop :( Snapmaker 2.0	9	2336	August 11, 2020
Bed adhesion is way too high Snapmaker 2.0	11	1618	June 26, 2021
Difficult to remove prints	21	3002	October 24, 2020