Leveling / First layer Problems

[Slartibartfass]

Please help me with bed leveling first layer mess uneven

I used thin washers (0.1/0.2/0.3MM) to shim the bed to level within 0.1mm. Used superglue to glue washers to undercarriage for easier bed replacement between the different use cases… Used a dial indicator for the measurements. Only have printed PLA but I go very slow on the first layer, preheat to 70deg C and drop to 50 deg C on follow on layers… Typically print around 210 noodle temp for first layer and drop by 5deg after that… Great results so far…

No issues with adhesion… Also go slow on first layer… See some of my settings…: