system just asked me to update version of Luban and so I did. I went to make a photo box I’ve done before with a new set of text labels. the initial movement speed to where it started cutting was slower then I remembered but it started cutting the box like normal but when it it finished one of the…

[image] yellow line not cut but others were

Scroll a bit up its luban bugs [image] Full Lightburn Control Guide Snapmaker 2.0 Please report the bugs you have found: https://forum.snapmaker.com/t/luban-v4-9-0-known-issues-solutions/33022?u=xchrisd

Check out this thread for currant issues and solutions/workarounds available: [image] Luban V4.9.0 Known Issues & Solutions Snapmaker Luban Seems a common issue! In case you didn’t see - if needed you can downgrade to 4.8.2 to resolve for now:

I had the same issue. I upgraded the Luban software and then updated the firmware and that solved the extra move lines problem. Luban 4.9.1 and Firmware 1.17.17 - also note that if you are several versions behind on the firmware, mine prompted me to update on the keypad, but not to the latest versi…

Laser didn't go off

Snapmaker 2.0 (3-in-1)

CandleFX September 25, 2023, 10:27pm 4

Check out this thread for currant issues and solutions/workarounds available:

Topic		Replies	Views
Snapmaker Luban Travel Settings Snapmaker 2.0 (3-in-1) Laser	1	464	September 29, 2023
Luban V4.9.0 Known Issues & Solutions Snapmaker Luban	47	3759	December 1, 2023
Laser engraving stopped working after firmware and luban updated Snapmaker 2.0 (3-in-1) Laser	2	481	September 26, 2023
Laser Focus Failing Since Update 4.1.2? Snapmaker 2.0 (3-in-1)	12	1250	December 28, 2021
Laser help after 4.9.1 upgrade Snapmaker 2.0 (3-in-1)	3	337	October 7, 2023

Laser didn't go off

Related topics