Laser 20w and original enclosure

Mayco · July 8, 2024, 6:49pm

INCORRECT INFO

You should be able to set M1010 S0

I don’t know if is saved to EEPROM though.

Sorry, this info only applies to SM2.0 as found in this topic: How to disable door open for laser? - #2 by buckfast_beekeeper.

In your case you do not have a sensor to put a magnet on, so I think your only option is modifying the firmware and remove this if statement:

github.com

Snapmaker/Snapmaker2-Controller/blob/9bf2233c0262516d7dcbe46d6f28e28da7d9f8c5/snapmaker/src/service/power_loss_recovery.cpp#L722


      
          		}
          
          		ResumeCNC();
          		break;
          
          	case MODULE_TOOLHEAD_LASER:
          	case MODULE_TOOLHEAD_LASER_10W:
          	case MODULE_TOOLHEAD_LASER_20W:
          	case MODULE_TOOLHEAD_LASER_40W:
          	case MODULE_TOOLHEAD_LASER_RED_2W:
          		if (enclosure.DoorOpened()) {
          			LOG_E("trigger RESTORE: failed, door is open\n");
          			return E_DOOR_OPENED;
          		}
          
          		if (laser->security_status_) {
          			LOG_E("trigger RESTORE: failed, laser security_status: 0x%x\n", laser->security_status_);
          			return E_LASER_SECURITY;
          		}
          
          		LOG_I("previous recorded target Laser power is %.2f\n", pre_data_.laser_percent);

Perhaps someone has a better suggestion…

Topic		Replies	Views
Frustration on enclosure door safety and support Snapmaker Artisan accessories	4	324	December 24, 2023
Snapmaker 2 - Enclosure	1	581	May 14, 2021
Laser won't set up because "door is open' Snapmaker Artisan	9	487	February 7, 2024
DIY Enclosure safety interlocks - any ideas? Snapmaker 2.0	6	1641	March 17, 2021
Beginner Snapmaker for CNC (drill bits, level, work speeds, density, enclosure, centre job) Snapmaker 2.0	2	4312	January 2, 2021

Laser 20w and original enclosure

Related topics