I can't drive Z-Axis in Manual Mode (Laser)

Hello,
I recently made an update to the newest Snapmaker 2.0 firmware ( I have the F350 ).
I didn’t made updates for long time so it could be a older update which changed following:
I can’t move the Z-Axis in Manual Mode if I want to laser something (see pictures).

At the moment when I want to laser something, I first have to use the Control Function to drive to my work peace, then I set the Z-Axis to my work origin point, then go to my file, use manual mode and then I should set the Z Height to set the focus. But I do this normally in the 2nd screen in my pictures. But after an update I cannot do this. Why is the Z-Axis locked in manual mode? How to get it usable? (I don’t do focus when I change to the laser module, never did this. I normally use the Z-Axis and all is fine).

Hi @iBlackStar49

Have you reached out to our official support team for troubleshooting? Please submit a ticket at https://snapmaker.formcrafts.com/support-ticket for assistance within two working days.