So I had to release the Nozzle to unclog some broken filament. After that there was a spark in the module. When I tried to insert the filament the nozzle was above 250°C and rising. I have the impression that the heating tube does not turn off now. Any suggestion of what I should do?

Have you installed the thermistor (white cable) properly to to heating module? The little glas drop should be located half way inside the small hole of the aluminum block.

Yep. The thermistor seems to be in the right place.

Things just got worse. I changed the module to the laser and it also does not turn off anymore. It is on at full power from the time I turn the Snapmaker on.

Then I think ther is a bigger problem… :disappointed_relieved: Please contact the service.

Some updates: Talking with service they suggested that there was a problem with my controller, I bought a new one and it finally arrived today. Unfortunately the printer does not initialize now It is in the starting screen for ever. :frowning:

Maybe try to update the firmware

Thanks for the idea, but didn’t work. Still the touchscreen is initializing forever. I connected the computer and seems to be able to control the printer with my computer.

Did you read this: [image] About the Reboot Screen (White Screen) Snapmaker Original Many users run into this problem lately: the printer works fine when suddenly the touch screen shows the white screen with the Snapmaker logo and just freezes. Now we have a theory of this…

Heating uncontrolably

Original (3-in-1)

rojaljelly January 22, 2020, 5:10pm 9

Did you read this:

Bed level from a PC

Topic		Replies	Views
About the Reboot Screen (White Screen) Original (3-in-1)	52	5619	June 22, 2019
Snapmaker wont do filament change Showcase & Prints	14	1996	February 10, 2018
Heating problem / Change Filament Original (3-in-1)	19	3734	April 15, 2020
Printer Never reaches target Temp Original (3-in-1)	3	896	October 23, 2021
Runaway overheating of hotend Original (3-in-1)	4	1529	May 6, 2020

Heating uncontrolably

Related topics