[First Batch Shipped Out] FAQs of Dual Extrusion 3D Printing Module for Snapmaker 2.0

[Hauke]

Hope I do not annoy anyone with flooding this thread with my observations… Since at some point I think of adding a Raspberry Pi with Octoprint to my setup, I was wondering how much power reserve the PSU might have to power that Raspberry with the dual extrusion head - turns out: none! The Dual head maxes out the PSU if you follow this thread: Snapmaker 2.0 A350 Power Supply Requirements - #5 by xchrisd - the single extruder may push it to 290W - so a second 30W heater may peak the power consumption to 320W, right where the PSU is spec’ed. I guess when I add the Raspi, it’s a seperate PSU for it…