Firmware 2.3.5: problem with vibration calibration

[i3sven]

I initially had a defective print bed holder, maybe check it out.

Snapmaker J1 Print bed holder broken

Hi, everyone, Yesterday I unpacked the J1 and a part fell out on me. At first I couldn’t allocate the defective component, but during a print I notice that the print is slightly different at the back. Then I wanted to adjust the bed again and realized that the middle rear part was defective or missing. Now I don’t have a secure print bed to print cleanly. Let’s see if it works, but I just created a spare part via Fusion360. Hope it fits. [IMG_20221226_145344] [IMG_20221226_145339] [IMG…