Filament Doesn't stick

[patch]

Hi!

I had/have a similar issues and got lots of good ideas! Maybe let’s habe a look at this thread as well:

Print does not stick

Hello! I just had the issue that I was printing a model and after some hours, the model obviously did not stick anymore to the heated bed and got off the bed. Then a lot of filament was just printing into the air ending up in a chaos - nozzle being full of filament etc. This happend now the second time to me and I have no idea anymore which settings I would need to change, calibration etc. I would be able to share pictures - I think it’s not possible to share in this forum (?). Any thoughts are…

I just tried a few days ago and have to admit that I am still not successful, but maybe there’s one or the other hint that might help you.

I think I really need to find somebody experienced now that comes to my home and has a look. May I am just too stupid

Regards,
Chris