Setting up to laser engraving. I get to the calibration step where it wants to turn on the laser. When I enter the Laser password, it starts to move then complains the enclosure door is open. I tried reversing the sensor plug with no difference. Then I power down the controller, but on power up it g…

Enclosure Door won't sense it's Closed

xchrisd February 8, 2024, 7:18pm 2

Maybe this helps:

Hope you share your solution.

Topic		Replies	Views
Laser won't set up because "door is open' Snapmaker Artisan	9	490	February 7, 2024
Door detection cannot be turned off at all Snapmaker 2.0	22	1414	June 5, 2025
Warning: Security issue - Enclosure door detection not checked at start/not fail safe Snapmaker 2.0	9	2149	July 12, 2023
SM2 Laser calibration failed (nothing engraved) Snapmaker 2.0	10	1651	August 17, 2020
How I can engrave something with enclosure door open? Snapmaker 2.0 accessories , laser	23	1032	December 9, 2023