Hi guys, I’ve put my Snapmaker Original inside its enclosure and I’ve also connected the doors contacts cable… with the last FW/SW have I to do something else like configuration or enabling the door open feature? PS: the door open pause feature is working just for the laser engravement correct?

Enclosure and FW/SW

xchrisd April 2, 2020, 9:25am 2

Here is the installation guide. You have to check at least if the doorswitch is responding correctly.

Topic		Replies	Views
Not able to activate the door detection Snapmaker Original	8	1182	December 8, 2020
Snapmaker refuses to work with enclosure Snapmaker 2.0	5	1038	September 22, 2020
Still issue with enclosure door feature Snapmaker Original	5	744	December 7, 2023
Opening the door on the SM Original enclosure doesn't pause the job, just shuts off the laser. Job ruined Snapmaker Original	0	387	February 20, 2020
When connected to Snapmaker Original, the laser does not go on for calibration Snapmaker Original	1	426	March 10, 2022