I think several of you reported that after using the DX’s Z-Auto-Calibration (which is really cool!) the Z-Offset is ~0.3-0.4mm too high, and when running the actual print, you have to manually lower the head. I certainly have this. Watching the Auto-Z-Calibration, I could see that when the head pre…

DX Z-Auto off by 0.3-0.4mm: Reason found, no Solution?

xchrisd October 29, 2023, 6:27pm 8

Didn’t verify but the dualextruder probe seems adjustable:

1 Like