I was reluctant to use the dual extruder after reading all the issues described here but decided to give it a try. I read all the suggestions, work arounds, tips and tricks and nothing seemed to work. I was getting extreamly frustrated and decided to take a step back by resetting everything to fact…

Dual Extruder works for me after starting from scratch

kwjw3 May 31, 2023, 8:06pm 3

Hello,
You can get details on how to do a factory reset here: How to factory reset my device?

As for Luban, I uninstalled and deleted all directories, then re-installed.

Hope this helps.

Topic		Replies	Views
Dual Extruder setup: What am I doing wrong? Snapmaker 2.0 (3-in-1)	31	1249	October 7, 2025
Dual extruder calibration Snapmaker 2.0 (3-in-1)	7	928	April 25, 2023
Reset to factory settings did not retain information about Dual Head Extruder Snapmaker 2.0 (3-in-1)	2	486	August 1, 2023
Dual Extruder Problems & Gripes Mega Thread Snapmaker 2.0 (3-in-1) Accessories	42	2517	April 28, 2023
Dual Extruder simply does not work Snapmaker 2.0 (3-in-1)	40	2331	April 22, 2023