This thread is for dicussion of the Snapmaker 2.0 Firmware Updates.

Just still wondering if on the A150 the 5x5 grid should also be available. Double checked and there is no chance to set it to 5x5 on whatever screen. It´s only the 3x3 available. Can someone of snapmaker confirm this? Thx!

I want to see an option to adjust the flow rate via the TS too.

Same issue for me with one axis not moving anymore midst print. I‘ve also noticed this issue with FW 1.8., I might try and go back to the last version to see if the issue persists

I also tried to go back to 1.7x but this not resolved my issue so I went ahead to the support. I‘ve checked with the support and my main axis rail with the bed mounted has a failure, so I think mine is coming from there. Edwin was super fast and gave me very nice support! Thx again at this Edwin! I…

Since 1.8.0.0 and 5x5 leveling, my A250 crashes into the bed at the beginning of the print. I have to home manually after the leveling, than it is working. with older Frimwares I never had to home manually after leveling. Does anybody else have this issue? At the first print after the upgrade I dama…

Did you re-calibrate after the firmware update? They tell you to do this every time you change the firmware. Either way try re-calibrating to see if it eliminates the issue. I have used both auto calibration and manual calibration on 1.8.0.0 and havent seen any bed crashes so far.

sure i calibrated it many times. every time the same issue. when I don’t home after levelling it crashes. I tested it, after I have levelled. Without homing, I drove the head manually until the nozzle touches the printbed, and than the Display said z-heigt: 4mm: [image]

Hey @hoaschter , you have to set the z-offset manually after automatic leveling. If you tap the Calibration Start button the axis are going home, then probing the grid points 1-25 (0-24), after that the head moves to the final point in the middle and waits for your calibration input.- After you lev…

Discussion of Snapmaker 2.0 Firmware Updates

Snapmaker 2.0 (3-in-1)

Waldo May 21, 2020, 9:11pm 128

I have not tried 1.8 yet, I’m a bit concerned about some bugs. But I would like to have CNC levelling implemented in the next firmware. Following is my implementation to achieve this.

Topic		Replies	Views
Discussion of Snapmaker J1/J1s Firmware Updates J1/J1s IDEX Firmware	204	8376	April 27, 2026
A350 Issues and Suggestions Snapmaker 2.0 (3-in-1)	24	8436	August 30, 2022
Firmware request J1/J1s IDEX	28	1963	May 5, 2023
Random HELP - Ask here! Snapmaker2.0 Troubleshooting guides	165	8459	January 12, 2021
Snapmaker 2.0 improvements Snapmaker2.0 Troubleshooting guides Feature-Request , Bug-report	34	3402	June 16, 2024

Discussion of Snapmaker 2.0 Firmware Updates

Related topics