I had an issue with circles not being cut/printed true round. I replaced the X linear module and that seems to have cured the issue. My SM2 has been running daily for 18 months, so I’m sure there’s some wear and tear. Can the old X module be fixed/adjusted or is it just one of those consumable it…

There have been a couple threads about maintenance [image] How to maintain the snapmaker in perfect condition? Snapmaker 2.0 Hello ! What do you use to maintain your Snapmaker in good condition ? Do you add oil on axis ? Do you you use special grease for crews ? Where …

It’s probably not worth the effort, only to realize it’s worn out. I’m just looking for some input if these things do actually just wear out eventually.

I got my Original back in 2018. I’m a low volume printer, maybe a couple prints per mount. Aside from retrieving things I’ve dropped into the unprotected rails, it’s still going strong. The V2 was redesigned to cover the openings to prevent dust and debris from getting inside. If anything, I wou…

My printer is in use avg 8 hours a day for 18 months. I’m sure it’s just worn out. And honestly, the cost in time to just swap it out is probably much less than trying to clean and adjust it. I may disassemble it using that guide at some point. Just to see how it looks inside.

What you are showing is backlash. The anti-backlash part in the Linear Modules is nylon, and can be readjusted, but it will eventually degrade to a point that it can no longer be used. It is a replaceable part, but you can only get them by contacting Snapmaker Support. You need to be extremely ca…

just have to point out, does anyone else think of Smash Bros when they look at the first picture?! haha

While some people have had problems where the bearings or guides have worn out it’s usually just that it’s developed play and needs adjusting. Especially if you’re doing a lot of cnc work. I’ve had to adjust mine a couple times in the 2 1/2 years I’ve had my 350. The procedure is fairly easy and doe…

Circles not round

Snapmaker 2.0 (3-in-1)

clewis December 12, 2022, 9:11pm 2

There have been a couple threads about maintenance

See if either one of those helps you out.

Topic		Replies	Views
Excessive play in x-axis linear module bracket Snapmaker 2.0 (3-in-1)	51	10323	February 1, 2023
Loose Linear Module w/ Workaround Attempt Snapmaker 2.0 (3-in-1)	20	2698	November 17, 2020
A350 - Not printing perfect circles Snapmaker 2.0 (3-in-1)	41	2952	August 12, 2021
Need support: linear module play Original (3-in-1)	16	1878	July 15, 2020
Linear rails maintenance and life span Snapmaker 2.0 (3-in-1)	11	2102	December 5, 2024

Circles not round

Related topics