I’ve gone through all the calibration settings on the teaching tech site: Teaching Tech 3D Printer Calibration But I absolutely can’t eliminate the stringing completely. I’ve gotten it down to either a very fine spider-web or some slightly sharper bits that stick out the side. But I can’t get rid o…

I print petg with 1mm @ 45mm/s Retract without Z-Hop. I guess 90mm/s is way too high, I don’t know the max speed but I guess there could be some filament grinding or slipping…

I’ve tried everything from 10mm on up. Speed doesn’t seem to be much of a factor in the webbing.

This is ridiculous. doesn’t matter what settings I use on this printer, the stringing will not go away. Is this problem just particularly bad for the Snapmaker? It was never this bad on my other printer. These settings have gotten the webbing as fine as it is, but it will just -NOT- go away complete…

Retraktion 5,4m!!! / minute ??? Thats a little bit to much I think :wink:

is your filament wet mate I have some stringing but that is really bad

No. Filament is dry. Heck this is southern nevada, it takes special effort to make it wet.

I’ve tried it all over the place speed wise. That’s just where is currently at because it’s where the stringing was the thinnest

I had a similar issue. Got really frustrated and pulled off the print head to check nozzle. the SM 2 came with a spare so compared it. Saw that the brass tip was worn down so I swapped them out. Has been much better since. Not for sure it’ll help, but wouldn’t hurt to check. [20210128_013650]

I guess I can check. My SN is still brand new. Thanks for the suggestion

Hello, thehouse! Do you know what type of filament you used and for how many hours to get that nozzle looking like that? I feel that 0.4mm compares to about 0.8mm in size:(

Can't Eliminate Stringing

Snapmaker 2.0 (3-in-1)

xchrisd February 8, 2021, 7:26pm 20

Hey, I completely forgot, have a look at this thread, good luck!

Topic		Replies	Views
Can't get rid of stringing Snapmaker2.0 Troubleshooting guides	3	717	February 3, 2022
Issues with my snapmaker 2.0 3D Printing Snapmaker 2.0 (3-in-1) Gcode , 3D_Models	26	850	January 7, 2024
Terrible stringing? Original (3-in-1)	8	1830	April 29, 2018
Calibration and Printing Issues Snapmaker 2.0 (3-in-1)	8	120	January 25, 2026
Help Needed with Optimizing Print Quality on Snapmaker 2.0 Snapmaker 2.0 (3-in-1)	1	527	December 27, 2024

Can't Eliminate Stringing

Related topics