Cannot Save Calibration

Hi,

My filament didn’t feed and it snapped mid-print.
Parts of the filament was broken and stuck in the tube.
I dismantled the nozzle part and managed to remove the tube.

I managed to remove the stuck filament in the tube and put it back.
Now it is feeding well.

The problem is now it refuses to save after the z-axis calibration.
I can see the “save” button but I simply cannot click save.

Any clues?

After it does however many measurement steps and parks, did you actually lower the nozzle head to an appropriate distance, manually, using the jog functions?

You need to adjust the Z offset and then the “save” button will be enabled.

Just an update that I needed to adjust the sensor 10mm above the nozzle tip. Now it is working. Thanks.