I have the original snapmaker. I recently purchased the enclosure and have been attempting to print with it. If I print with the door open, everything goes fine. If I print with the door closed the extruder just starts pouring out filament to the left of the print bed. If I start printing with the d…

Are you running the latest firmware? There were a couple version that had weird behavior with the enclosure. You can check on Settings > About, first line. I have 2.11, and it says “Snapmaker-GD32Base-2.11”. You can download the latest in Downloads and Updates for Firmware .

Same issue here. Just received my Snapmaker Original today, assembled everything, made sure I installed the most recent firmware (2.11 it is). The first print started fine, but when I closed the door of the enclosure, the erratic behaviour Kate experienced occurred almost instantaneously. My second…

Yup, same issue here. I was starting to feel stupid trying to figure out what was causing the printer to go nuts. Mine moves the head far off the build platform and up by about 20mm then continues to move as though it’s printing the proper shape but dumps filament spaghetti onto the printers alumi…

Cannot print with enclosure door closed

Original (3-in-1)

svsik January 18, 2022, 12:34am 4

This looks like duplicate of Trouble printing with enclosure v1.1 - #14 by PhilR

Topic		Replies	Views
Trouble printing with enclosure v1.1 Original (3-in-1)	17	1730	October 29, 2022
Still issue with enclosure door feature Original (3-in-1)	5	769	December 7, 2023
Door Switch causes problem Original (3-in-1)	9	1258	December 22, 2023
Snapmaker refuses to work with enclosure Snapmaker 2.0 (3-in-1)	5	1084	September 22, 2020
Enclosure and FW/SW Original (3-in-1)	4	561	April 3, 2020

Cannot print with enclosure door closed

Related topics