Cannot print with enclosure door closed

I have the original snapmaker. I recently purchased the enclosure and have been attempting to print with it. If I print with the door open, everything goes fine. If I print with the door closed the extruder just starts pouring out filament to the left of the print bed. If I start printing with the door open, then close the door, same thing.

Any suggestions?

Are you running the latest firmware? There were a couple version that had weird behavior with the enclosure. You can check on Settings > About, first line. I have 2.11, and it says “Snapmaker-GD32Base-2.11”.

You can download the latest in Downloads and Updates for Firmware .