Calibration pushing deep into buildplate

[NilartPax]

There is info over here on how to turn on these options, but it isn’t recommended.

SM2 Bed Leveling

@Tone It should be in effect otherwise higher layers will not match with lower layers. @Tone @DroneOn @Raptor @onyx0909 @Jayberz For the guys mentioned about the “icons”, there is an way to turn on dev mode of TS, with 2 more apps “Factory” and “Experiment”. But I don’t recommend you to turn it on since only very few options people would need (unless you have a bed leveling issue and want to disable to fast calibration before print), and contains options that are debug-only that will caus…