I just received the new lineair modules. Installed them like they should be installed. ( y and x 20 mm and the z 08 mm) all the cabling is going to the correct ports. Homing is fine also when jogging all is good. But when i hit calibrate it goes down to the bed and the bed starts moving backwards. …

[image] Snapmaker 2.0 New Linear Module XY Issue & Solution Snapmaker 2.0 This happens when M92 is used - there’s a patch on Github, hasn’t been published yet. The workaround now is M502 to reset all settings, then M500 to save, then power cycle the machine.

Thanks Brent, that did it. Should have thought about that.

Calibrating with new modules goes wrong

Snapmaker 2.0 (3-in-1)

brvdboss April 24, 2022, 3:16pm 2

Topic		Replies	Views
Snapmaker 2.0 New Linear Module XY Issue & Solution Snapmaker 2.0 (3-in-1)	5	1579	June 30, 2022
M500 not saving calibrated M92 X,Y, Z values Snapmaker 2.0 (3-in-1)	7	1194	November 18, 2021
Machine calibration problems Snapmaker 2.0 (3-in-1)	26	3592	April 18, 2022
Horrible grinding noise on Y Axis after new LM Install Snapmaker 2.0 (3-in-1)	19	2431	July 3, 2023
Linear Module defective and FW 1.8.0.0 Feedback Snapmaker 2.0 (3-in-1)	15	2837	September 1, 2020

Calibrating with new modules goes wrong

Related topics