Bed is not level

[brent113]

…lmao @stefix

@Askbruzz Check out @moosejuice’s thread here:

What are the rules of thumb with various calibration and 3D print settings in Luban?

I have generated a pair of macros for an 11 x 11 calibration routine with the heated bed on. You can try this if you like, i cant say with certainty it is ideal at this time there is speculation about the heated bed affecting the sensors but i feel like it would be relatively consistant First preheat your bed to the temp you want to run at. i need to edit the macro to add a wait for temperature. i have to test a little bit to make sure i put it in the right position but if you preheat before h…