Axis Movement Issues

Snapmaker 2.0
21

VERY glad that worked for you! Let’s hope it stays functional and doesn’t have some sort of sensitivity to running a long time or something…

I totally confess that was a wild ass guess, similar to when I’ve had computer issues or monitor compositor issues. Unplugging, leaving off for a while to clear some sort of CMOS state so it reloads from BIOS/firmware directly? Letting some sort of temp or overvoltage sensor reset? I honestly have no idea, but these days it’s almost always worth a try… :smiley: All it costs is a little time.

22

Make sure you run the macros in Luban workspace you will get a indication if the one of the modules are bad. I had two bad Y axis on my 350 that had to be replaced twice no works fine.

23

Turned out it’s likely a bad Y axis cable. It was going M1005 “emergency stop”. We’ll see.