Alternative way to install Quick Swap Kit if you have an enclosure (and don't want to take everything apart)

Snapmaker 2.0
1

I wasn’t feeling like taking my SM 2.0 and the enclosure apart for the install of the quick swap kit as you need to access some screws through the bottom of the SM 2.0 (thank god there are access holes in the bottom plate…).

I used saw horses and a second desk plate to move the SM 2.0 partially onto and than created a gap underneath to access the screws… Work smart, not hard…

IMG_2818
IMG_28181920×1440 166 KB

IMG_2819
IMG_28191920×2560 301 KB

IMG_2820
IMG_28201920×1440 182 KB

IMG_2821
IMG_28211920×1440 184 KB

IMG_2822
IMG_28221920×1440 171 KB

IMG_2823
IMG_28231920×1440 238 KB

1 Like
2

With my A350, I can lift the printer out of the enclosure without dismantling it or the enclosure. I do not even dismount the brackets that fixate the A350 at the bottom. If you tilt the printer, you can wiggle it through the larger door. Did so when I installed my QSK.