https://www.facebook.com/groups/1444297182358728/permalink/2889953617793070/ (See links) Like the top link After finishing printing, there is a problem that the z-axis comes down and finishes. Eventually, the output of 20 hours was destroyed. Others also asked if there was a problem with the z-…

After installing the z-axis extension. At the end of the output, the z-axis descends and spoils the output

xchrisd July 30, 2020, 9:24am 7

It’s the same problem.

Topic		Replies	Views
Z Axis Not Moving Down Snapmaker Original	1	509	February 11, 2021
Z-axis moves very slowly Snapmaker Original	6	367	September 25, 2020
I'm running into problems where my Z isn't going down Snapmaker Original	2	1091	January 27, 2021
Z Axis sag ruins levelling Snapmaker 2.0	5	419	April 3, 2021
Taller Builds knocked off by X-axis arm Snapmaker Original	18	1444	January 16, 2021