Hello SnapMakesr fellows.
I just got my SM 2.0. and i’m a newbie to 3D printing.
In the first run, the extruder placed it self in the middle of Z axis, outsite the headbed and run out some filament, then it waited a moment , so it could be removed before printing. I had V.1.8.1 firmware as factory delivered.
Then i made a firmware update to v1.10.1 and did a new calibration.
But now the extruder goes all the way down of Z-axis, outsite headbed, run some filament and then right away, move into the bed area and start printing.
Is it me that are doint something wrong or is there somthing with that firmware version that should be correctet?