Hi everyone:) I have purchased a used snap maker original and I would like to pause the program to change the filament. Can this be done??

Its would be very difficult to do so. It is maybe possible but you have to tinker in the gcode. [image] M600 command for Snapmaker Original Snapmaker Original Dear colleagues, As i’ve seen this M600 code feature is available for SnapMaker 2.0, but i have Snapmaker Orig…

In theory, you could insert some movement codes that does a very slow movement forward and back and lasts a minute. The Original is manually loaded, so you can push the load button, and pull and push the filament any time you want, if you can keep up with the head moving. I’d practice load and unl…

I find it easier to load since I installed a flexible filament guide piece in the print head. Bit fiddly to do, but fills a bit of the space where the filament could curve into and get off path. It helps stop flexible filament bunching up in the void inside the head (I had some Silk PLA that was do…

Nice. I’ve occasionally printed some polypropylene, and it will on occasion coil up inside the print head instead of going out of the nozzle. I was thinking I should do something about that. If it makes loading filament easier, even better. I haven’t attempted this trick, but I don’t see why it …

It is possible and I do it all the time. To the best of my knowledge Luban does not directly support this but Cura Slicer does. See extensions and an easy option to add a filament change at the appropriate level. Most slicers allow you to scroll up and down and see how the printer builds the 3D p…

This thread is about snapmaker original, did you notice?

Sorry. I am working around the clock and missed the “Original” in the title. It did not appear elsewhere to the best of my knowledge. In general all the rest of my point are on point and I believe helpful.

Used snapmaker original

Original (3-in-1)

xchrisd September 11, 2023, 6:42pm 2

Its would be very difficult to do so.
It is maybe possible but you have to tinker in the gcode.

Topic		Replies	Views
M600 command for Snapmaker Original Original (3-in-1)	5	865	August 5, 2022
Is M600 (Filament Change) Available on the Snapmaker Showcases & Tips	37	4653	September 5, 2022
Add Command `M600` in Your G-Code File Official Articles	44	13372	September 19, 2023
Multi-Color Printing with Filament Change Pause? Snapmaker Luban	8	2376	January 11, 2021
Possible to change filament during paused printing? Snapmaker 2.0 (3-in-1)	31	8556	December 29, 2022

Used snapmaker original

Related topics