U1 JointLab — Coax strain relief for a weather satellite receiver

I have read and understood all rules of the Innovation Fund Phase 2

on

I consent to my project information (username, project cover, summary, etc.) being publicly displayed for review and showcase

on

Username (for public display)

adr1el

Project name

U1 JointLab

Project URL

Project cover

Project Category

Hardware MOD

Project Summary

I’m building a Raspberry Pi and RTL-SDR ground station to receive Meteor weather satellite imagery. A tug on the antenna cable can put load on the SDR’s small RF connector. I’m designing a strain-relief bracket that transfers that load to the receiver base. A rigid PETG body anchors the bracket, and a flexible TPU saddle grips the cable jacket.

JointLab compares three ways to join those materials: a plain seam, Snapmaker Orca’s beam interlock, and a mechanical key built into the model. The first test specimens are modeled and available in the project repository. I’m requesting one Snapmaker U1 to print PETG and TPU in the same part using separate printheads and material settings. I’ll measure peak pull force, document how each joint fails, and compare the most promising interlock with the plain seam on the receiver bracket.

I’ll share the U1 print project, fixture instructions, and results so other makers can repeat the comparison and adapt the design to their own cable mounts.

Open Source Status

Closed Source

Please specify the open source license used by this project

N/A

Cash Fund or U1 Hardware Sponsorship

U1 Hardware Sponsorship

Originality

Original New Idea

If based on an existing project — your independent contribution

N/A

Is it a paid project?

No

update the project URL link.