I have a Snapmaker A350, which has given me nothing but trouble. Namely strings all over my Benchy, as if a horde of spiders attacked it. I am using Snapmaker PLA. I live in a rainforest, so I am assuming myfilament is simply too wet. So it has been sitting in a vacuum bag for a week with 8 poun…

Here are some recommended standard settings that you can compare with your values: Temperature: Nozzle Temperature: Try starting with a slightly lower nozzle temperature. For PLA, you might want to start around 190-200°C. Higher temperatures can increase stringing. Retraction: Retraction D…

In my understanding, others out there feel to correct me, desiccant alone will not dry the filament. You need to warm the filament to drive out the absorbed moisture. Desiccant will help with moisture reabsorption once “dry”.

This high retraction would clog the nozzle. 1mm is enough for normal retraction settings. Post Ai generated?

Whenever I get a lot of stringing, it’s usually due to printing temps. I live in a high humidity area too, but I have dryers to keep the stock dry…

Sadly I don’t have an enclosure. I bought one, it was delivered, but I never got it. I suspect porch pirates.

It’s not the ambient air temp that needs adjusting. Try bumping your print temps by 10 Degrees or so. See how that goes.

Thank you all. Next attempt is tonight!

Not much luck, sadly. It looks pretty awful. Ideas anyone? [20250626_193232]

Print a temp tower and dry your filament. [image] 3d Print Guide_Walk Through Temperature Tower from Simplify3d on thingiverse Temperature Tower by Simplify3D - Thingiverse [TempTower] Here are some gcodes, print time 1,5h; 8g filament: Snapmaker Original Temperature Tower 190-225°C: SM-O…

Actually, aside from the blobs and strings, your benchy looks decently good! Did you check the retraction settings? To me it looks a bit like the printer does not retract filament, but spits out extra filament… Which would be weird… Perhaps start trying one of the Luban default profiles for PLA? Th…

Trying again to get past Benchy

Snapmaker 2.0 (3-in-1)

xchrisd June 27, 2025, 6:31pm 10

Print a temp tower and dry your filament.

Topic		Replies	Views
Terrible stringing? Original (3-in-1)	8	1820	April 29, 2018
"Stringing" and retraction functionality Original (3-in-1)	6	4086	December 30, 2022
Help Qualitaty Check with a Benchy Snapmaker 2.0 (3-in-1)	14	210	June 21, 2025
Can't Eliminate Stringing Snapmaker 2.0 (3-in-1)	19	2207	February 8, 2021
Calibration and Printing Issues Snapmaker 2.0 (3-in-1)	8	107	January 25, 2026

Trying again to get past Benchy

Related topics