Hey all, I’m having an interesting problem and I’m not sure what’s what. My top surface for these prints almost look like they are low resolution and marred. I’m not entirely sure why. I’m using Cura ATM and the entire print turns out really well at 0.12mm, save for the top. I’m currently messing wi…

Looks to me like you might have a little moisture in your filament. This is a very common problem. You can bake it in your oven or get a food dehydrator. Almost every spool I open needs baked a bit…

@Streupfeffer If your talking about the e-steps I did do that…but I’m reading that each filament is different on that thread, so maybe I should give it another go-whirl since I’m using a different spool. Thank you for your reminding me! @MooseJuice I’ve actually never done that…but it’s a good poin…

i have to dehydrate nearly every spool. some of them are worse than others, but it ALWAYS improves the quality. even fresh out of a vacuum sealed bag.

@MooseJuice @Streupfeffer , of all the things…it was printing at a lower speed that seemed to be causing it. I noticed it on another print and it was a definite line. I checked out my top layer settings and started changing them one by one, when I got to speed it was gone. Kinda weird how printing sl…

interesting. i suspect its probably other issues working together and getting it faster was just able to hide it. its really hard to say - there are so many variables… perhaps the nozzle itself was melting the top plastic a bit so speeding it up allowed it to lay filament without doing so.

Top Surface Ugly

Snapmaker 2.0 (3-in-1)

Streupfeffer December 28, 2020, 1:41pm 2

Maybe check yout this thread? Form the smal things on the Surface, you might getting overextrusion which over time presses out tomuch filament and leaves this “worms” Extruder Calibration a must

Topic		Replies	Views
Uneven laying - filament related? Snapmaker 2.0 (3-in-1)	17	1353	November 12, 2020
Bumpy print walls Snapmaker 2.0 (3-in-1)	7	684	January 23, 2021
How to achieve smooth top surface Snapmaker2.0 Troubleshooting guides	5	641	July 18, 2021
Weird small spots on the surface of prints Snapmaker 2.0 (3-in-1)	4	501	February 26, 2021
Smoother top surface Snapmaker2.0 Troubleshooting guides	3	2007	November 13, 2021

Top Surface Ugly

Related topics