Hi there - again a newbie … I recently shredded my hot end and tried to clean/repair it afterwards. In the end - after everything was clean again of course - the thermistor was kind of fixed inside that drillhole. in short - the cable ripped of the thermistor and I ended up installing another hotend …
Question: Does anyone know what thermistor it actually is and does it make to replace the sensor (the hotend is not that expensive …). And, regarding your tipp above, do you have a sample product (e.g. amazon or likely) … thanks a lot!!
ADD: just found the thermistor in this thread:
Thermistor replacement cable - Snapmaker Original - Snapmaker: where creation happens