Hi Xchrisd,
I cannot upload my complete gcode file.
It says: “Sorry, that file is too big (maximum size is 4096kb).” (its 28 MB because it is a big model).
Should I then only upload the last 4kB of it?
Or you can just use the thingieverse STL of https://www.thingiverse.com/thing:919475 - I sliced the “FilleniumMalcon-FrontHalf_Pegged.obj” in “normal quality” in snapmakerjs.
Greetings,
Sven
(PS: My original post is here Reset run killed my print at the end)