After over a year of using my A250 without too many issues, updating to v1.14.3 has seen nothing but problems. But this one is the strangest…
Again, I loath updating software, but the compelling feature to preserve the enclosure LED state was too alluring.
If that’s all you’re after I had a modification to the enclosure module firmware that just had it turn on at power on by default. This is the only change:
Ramp up to full brightness (instead of stopping at 200 like it previously did) and then go straight to the “on” state machine state rather than transitioning to a ramp down to “off”.
That would be great to have, but I have no idea how to get the file/binary from GitHub.
