Snapmaker does not turn on

[xchrisd]

May start with measuring the power supply, is the supplied voltage correct?

Symptoms of a weak power supply

Print stops for no reason. Laser stops for no reason. Prints take significant more time than the software estimated. Layer shifts during print. (Also caused by too fast a print speed) These are the issues I was having. I did a voltage droop test with the machine running and it was down to 22.6 volts. I replaced my power supply (after spending $94 on a new controller that I didn’t need) with a 24v/6.5a Meanwell power supply from Amazon for $18. Tested the new power supply. Have 24.2v loaded. …