If you got a late dual extruder toolhead there are little rubberpads where the wedges should be. I disassembled it with needle nose plier so the wedge would fit.
Additionally i printed the snapmaker frontdoor to be sure.
Never heat creeped again…
Wedge
Hallo, @brewery.chump0x
Klar teile ich es mit Dir / Euch.
Anbei die STL und Auszüge aus der Mail vom Support an mich.
Grüße
—————————————-
Hello, @brewery.chump0x
Of course I share it with you.
Attached is the STL and excerpts from the email from support to me.
Greetings
Block.stl (158.2 KB)
[image]
[image]
Door alias front plate
Hi all,
so finally got around trying the new door design, and it was a full success! The model that failed after less than 20 mins before, now went through in 7 hours. The filament does not show any hint of broadening/heat creep, neither on left nor on right nozzle. Already informed support about the success, now waiting patiently for what they make from it - my assumption is that they’ll release a new front door and send this to those affected. I am curious how many this might be - would you m…