I have a 40w diode laser in snapmaker and when i had the 10w it was all fine . but the 40 w has problems .eg with my job is say 100mm by100m . i cut a sheet of MDF 120 by 120. so little waste . put it in machine and run a boundry , adjust so boundry draws a line inside the piece of wood . then i b…

With Lightburn it is a bit tricky - first, look at this page: https://wiki.snapmaker.com/en/general/manual/use_ray_with_lightburn_guide There are profiles for the different lasers in Lightburn. And than it matters if you select Marlin or GRBL as flavour in Lightburn. I seem to remember that the pr…

[image] Hauke: EDIT: and of course be aware of this one: [image] 1064nm IR+20/40W + Lightburn Guide Snapmaker 2.0 (3-in-1) With the new IR laser coming out, I figured testing and guides would follow. Lucky enough, it seems with minimal tweaks, Lightburn …

Snapmaker 40W boundry dont work

Artisan (3-in-1) Artisan Troubleshooting guides

Skreelink March 17, 2026, 5:11pm 3

This one is more updated.

Topic		Replies	Views
40W laser running out of boundary (lightburn) Artisan (3-in-1)	30	2111	June 3, 2025
Snapmaker ray Laserstärke funktioniert nicht mit Lightburn Ray (Laser)	7	186	September 17, 2024
Snapmaker 2.0 40W and lightburn does not work Snapmaker 2.0 (3-in-1) Troubleshooting , Lightburn	2	127	November 16, 2025
Help! Snapmaker Ray 40W and Lightburn won't work with many issues Ray (Laser) Laser , 20w40w	11	1072	March 18, 2025
Lightburn et snapmaker Snapmaker 2.0 (3-in-1)	1	72	October 29, 2024

Snapmaker 40W boundry dont work

Related topics