Hi all, I just had a print fail and a nozzle clogged, and finally found the thermistor to be the problem. It had almost worked its way out of the hot-end. There seems to be nothing that holds it in place, except the wires it’s soldered to. The spare hot-end is equally flimsy, thermistor just put in …

An article that was brought up just recently. You might find it useful. [image] Whats wrong with this picture - printre hot ends Snapmaker 2.0 So was swapping hot ends to a different nozzle diameter and noticed the thermistor bead is just loose and in poor contact with t…

Thanks! I’ll try some thermal glue.

Should thermistor be loose in hot-end?

Snapmaker 2.0 (3-in-1)

Blockmodule February 12, 2021, 10:52am 2

An article that was brought up just recently.
You might find it useful.

Topic		Replies	Views
Whats wrong with this picture - printre hot ends Snapmaker 2.0 (3-in-1)	52	4295	July 1, 2025
SM 2.0 Hotend temperature sensor Snapmaker 2.0 (3-in-1)	10	1148	May 24, 2021
Temperature on hot end module Snapmaker 2.0 (3-in-1)	7	959	January 11, 2021
Hot end loose wires? Snapmaker 2.0 (3-in-1)	5	1115	September 15, 2020
Bad hot end? Snapmaker 2 Snapmaker 2.0 (3-in-1)	22	918	January 18, 2021

Should thermistor be loose in hot-end?

Related topics