Rail question (square)

[SnapSnap]

I’ve loosened the linear rails and readjusted them with some shims I’ve printed bevor according to this post:

Findings and solution for the Snapmaker J1 clogging problem

Snapmaker replied to me today about the problem with the rattling on the X-rail: German: Snapmaker hat mir heute geantwortet auf das Problem mit dem Rattern auf der X- Schiene: Please check the clearance between the silver bracket and the black X-axis die-cast part, there should be a gap of approximately 0.5mm here. If you find any wear on the black X-axis die-cast part, please refer to the picture below, loosen all the screws on the linear rails of the X-axis, adjust the clearance and tighte…